Akai PR-A04 - Page 22

V. VOLTAGE CONVERSION
FRONT
}
sw!
110V
ay
240v
PULSE POWER
SUPPLY UNIT
SHORT PIN JACK A
RECTIFIER
P.C BOARD A ———a
PAW~4043,
FUSE Fl,2
HOV: T4A
220,240V:250V 2A
REAR
Fig. 4 Voltage Conversion (U/T Model)
1. U/T Model (Refer to Fig. 4)
1) Switch OFF the power supply and remove the
plug from mains supply.
2) Loosen holding screws and remove top panel.
3) Align the short pin jacks A and B with the position
for each voltage area as shown in Fig. 4 and then
plug in.
4) Set the slide switch located at the right hand side
of the pulse power supply unit Fig. 4.
5) Change the fuses, 4 A for 110 V and 2 A for 220 V
and 240V.
2. Models other than U/T
No voltage conversion.
22