Akai PR-A04 - Page 8

V. VOLTAGE CONVERSION
SCREW
Seem Ceemrarere |
IS sr ATES SER CE LC RNS aa
FUSE
PC
BOARD
(PRA-
4003)
=
POWER SWITCH
ry i
POWER TRANS,
Fig. 4 Voltage Conversion (U/T Model)
1. U/T Model (Refer to Fig. 4)
1) Switch OFF the power supply and remove the
plug from the mains supply.
2) Loosen holding screws and remove the top panel.
3) Remove the screw holding the Fuse P.C Board
located near the power transformer.
4) Remove existing Line Voltage Fuse and insert
required Line Voltage Fuse in the proper fuse
holder.
110V : 800mA 250V
220V : 400mA 250V
240 V : 400 mA 250V
’ 2. Models other than U/T
No voltage conversion.