Akai S01

3. Selecting
A
Parameter
Using two
cursor keys
(right/down), select the
desired
parameter by
lighting two
parameter LEDs
corresponding to
the desired
parameter. Each time
the
cursor right key
is pressed,
the LED light
will
move one step
to the
right.
In the same
way,
pressing the
cursor
down key
will move the LED
light
one
step
down.
To
move in the
opposite
direction,
holding
down either
cursor key,
press the
other
key, and
the
direction
of the LED
light will
reverse. As
in the
diagram below
the
LED will
return
one step
at
a
time.
*
The PROG.
NO./DATA
display
will show
the current
value
of the selected
parameter.
OIBIM 1 O
LOOP
I O
LEVEL
I O
PITCH I
©
MIDI I
©SETUP
I©
DISK
oin
mnmn
m.
LfVStMFniK
c=£>
Example:
Selecting
"PROG. NO."
in
the
MIDI
index
light
START
POWT
START
FINE
tOOl"
/ONE SHOT
light
I
•
SETUP
I •
DISK
transpose
KEYRANQI
MIM
HMH
TRANSPOSE
MONO
TmaoER
SAMPLE
TUNC
KETftANOB
LOW
MASTER
TUNE
6HD POINT LOOP
POINT VELOCITY
CONSTANT
PITCH
•ItW&SNS-
P.CHAHOE
CHANNEL
*~ii
END ME
LOW PINE
MIDI
CHANNEL
LEVEL Httm
There
is
also
one more
method
by
which
the
parameters can be
selected.
As the
cursor
right key
is
held
down, turn the
data entry knob to
move to
the right or left.
Then as the
cursor
down key
is held
down,
turn the data
entry knob to
move up
and
down.
4.
Setting the
Parameter Values
Set the
selected
parameter's
value using the
data
entry knob. The
value
will
be
shown in
the PROG.
NO./DATA display.
25