Akai S01

Reception
To
Receive MIDI
Sample
Dump Standard
Format
Data
Use
the
method for manual sampling. First
press the REC
key in Play
mode, and set the trigger
level
to
100
(manual sampling) using
the data entry
knob.
While holding down
the REC key,
press a bank key that
the data is received in.
Start sending the data
from the transmitter, the PROG.
NO
./DATA
display on the SOI
will show
"rev"
while receiving it.
To
Receive S01
Exclusive Format
Data
Any special setting is not required. Unless the disk drive
is accessing
a disk or sampling is being
done,
the
SOI will receive that
data. Start sending the
data from the transmitter,
the PROG. NO./
DATA
display on the SOI will show
"rev" while receiving
it.
*
The
801 has
a
fixed sampling
rate
(:
FS, sampling frequency)
of 32 kHz. If
a
sample
data
that
was created
at
a
sampling rate other
than 32 kHz is
loaded into the
S01
,
you should edit the
sample using
the TRANSPOSE
and
SAMPLE
TUNE parameters,
referring
to
"Sampling
Frequency-to-TRANSPOSE/SAMPLE
TUNE
Conversion
Table" on
page 53.
Also,
see page
45
for detailed
information
about this.
Dump
Request
Whenever
the SOI receives the
dump
request message from
an external MIDI
device, unless the disk
drive
is accessing
a disk or sampling
is being done, the
SOI will
start to send the
bulk data according
to the message.
Additionally, while
bulk data is being
sent, the PROG.
NO./DATA display will
show "Trn".
47