Akai S01

Default Program
and
Parameter
Attributes
for
Bank
1
When
the
SOI is
turned
on, it will
automatically
load the
default
program
unless any disk is set
in the
disk
drive. The
default
program
includes
basic
parameter
settings for
the SOL
Also, each parameter
is
categorized
into three
depending on
the function:
sample setting,
bank setting,
general setting.
Therefore
it
will
be
saved or
loaded
along with
associated ones.
Finally we add
information
concerning the
default
program and
each parameter's
attribute
for
reference.
Index
Parameter
Default
Value
Attribute
File Attribute
TRIM
START
POINT
Sample
ALL/SAMPLE
START
FINE
Sample
ALL/SAMPLE
END
POINT
Sample
ALL/SAMPLE
END FINE
366
Sample
ALL/SAMPLE
LOOP
LOOP/ONE
SHOT
ON
Sample
ALL/SAMPLE
MONO
TRIGGER
OFF
Bank
ALL
LOOP
POINT
Sample
ALL/SAMPLE
LOOP
FINE
366
Sample
ALL/SAMPLE
LEVEL
LEVEL
80
Bank
ALL
RELEASE
45
Bank
ALL
VELOCITY
ON
Bank
ALL
PITCH
TRANSPOSE
Bank
ALL
SAMPLE
TUNE
Bank
ALL
CONSTANT
PITCH
OFF
Bank
ALL
BEND
2
Bank
ALL
MID!
KEYRANGE
HIGH
127 Bank
ALL
KEYRANGE LOW
Bank
ALL
PROG. NO.
1
Bank
ALL
MIDI CHANNEL
ON
Bank
ALL
SETUP
MIDI TRANSPOSE
General
ALL
MASTER TUNE
General
ALL
P. CHANGE CHANNEL
ON
General
ALL
DISK LOAD
__ _
—
SAVE
__
—
—
DELETE
—
—
—
FORMAT
—
_
—
Attribute: What the
parameter affects.
"General" parameters
are used
for
the
SOI setting.
If
the
default program is
loaded, current "Sample"
and
"General"
parameters
are
not affected whereas
"Bank" parameters
are overwritten
and affected.
When a
SAMPLE file is loaded,
current "Sample"
parameters
are
overwritten
and
affected.
When
an
ALL file is loaded, all
parameters are
overwritten
and
affected.
File Attribute: File
format that
contains
a
specific parameter.
Parameters
marked
with "ALL/
SAMPLE"can be loaded as
sample data
along with a
sample
(SAMPLE
file).
Also,
each
sample
data
contained in
an ALL file can be loaded
in
extraction as a
SAMPLE
file. In this case,
however, there are some
restrictions. See
page
44
for
detailed
information.
51