Akai X-150D User Manual

6. VOLTAGE AND CYCLE CONVERSION
POWER VOLTAGE ADJUSTM!
The Model X-150D is operatable
stepdown power ie user can ¢, b
one
of
the
six
ve
00
t0
240
ve
ally, t oe age is pr ry
The user is requestes k the pr Z
This can be seen at the rear of the recorde
If another volt quired, readjust
1) Take off the cover panel by removing twe mounting screws as shown
Fig. A, ‘Then, pull out the VOLTAGE CONVERSION SWITCH
gently
ani
the
knob
so
th
re
will
appe
h
vanel, (See Fig. B
The voltage conversion switch is a plug-in t
110, 120,206 40. For example, if
your ar 220 Volts A.C, reset the
3) Change fuse according 10 volta
Fuses WOW ~1J0V OBA, 200V~240V
CAUTION: Disconnect the power
life of your machine, it is important that the line
percent deviations from the standard. valtag
POWER CYCLE CHANGE
Correct tape
speed isn able it the CYCLE CONVERSION
SWITCHES are no The CYCLE CONVERSION
SWITCIT
(A)
@
is
located
atthe
of
the
CYCLE CONVERSION SWITCH B @ at ¢ der. Us
Me
the
CYCLE
CONVERSION
SWITCH
(A
‘ounter clockwise approximately one-eighth of a turn. ‘The switch can then
be moved either OUT or IN. 50 evele operation is obtained by moving
the switch OUT (Fig. C), and 60 cycle jon, by the switch IN Fig. D
The switch @ should be rotated back (0 its original
been moved either OUT or IN. ‘The CYCLE CONVERSION SWITCH
B) @ should
CAUTION: — De
SWITCHES when the ni
he CYCLE CONVERSION
ERAL INFORMATION

Akai X-150D Specifications

General

Brand	Akai
Model	X-150D
Category	Tape Deck
Language	English