Akai X-360

4.
16
Adjustment of Tape
For all measurements, use 60 mm diameter tape,
and measure tape tension with a Tension Gauge.
Set the Magnetic Brake Control Switch to
STANDARD. :
1) Back tension for “Reverse Play” depends upon
2)
the torque of Motor B, as shown in Figure 6.
Adjust back tension to 60 grams adjusting the
230 Q Resistor (F), as shown in Figure 5. At
this tension setting, voltage applied to Motor B
is approximately 29 V.
Take-Up tension for “Normal Play” depends
upon the torque of Motor B, as shown in Figure
6. Adjust take-up tension to 100 grams by
adjusting the 120 Q Resistor (A), as shown in
Figure 5. At this tension setting, voltage applied
to Motor B is approximately 41 V.
cI ao) =
i
©
——
Tm
Alb
i= -—-©
ieee Ae
= <—
| |
B fr |«
B i
©} w
CINK,
es
3)
@
Die
& Q_
Back tension for “Normal Play” depends upon
the torque of Motor A, as shown in Figure 6.
Adjust back tension to 60 grams by adjusting
the 230 Q Resistor (F), as shown in Figure 5.
At this tension, voltage applied to Motor A is
approximately 29V.
Take-up tension for “Reverse Play” depends
upon the torque of Motor A, as shown in
Figure 6. Adjust Take-up tension to 220 grams
by adjusting the 120 22 Resistor (A), as shown
in Figure 5. At this tension, voltage applied to
Motor A is approximately 62V.
ZL ETENSION ADJUSTMENT OF TORQUE MOTOR
BPH. HEAD REVERSE TIMING
© BACK TCNSION OF T.F. & RWD.
(MAGNETIC BRAKE D.C. ADJUSTMENT
f
@
“
)
———.
>
Wie
Ag
‘
ge,
(E) MAGNETIC BRAKE A.C. ADJUSTMENT
mY: (E TENSION ADJUSTMENT OF
(0) TORQUE MOTOR
e © PROTECTION RESISTOR
AG) OF PINCH ROLLER
LA SOLENOID
eer
ee
| =