Akai X-360

IX. MAINTENANCE PROCEDURES
1. LUBRICATION INSTRUCTION
For maximum service life and optimum performance,
lubricate the parts identified below after each
1,000 ~ 1,500 hours of operation. Use only light
machine oil of good quality.
Main Motor
Capstan Shaft
Pinch Wheel Shaft
Tape Counter
Also apply a liberal film of light machine grease to
each roller surface of all levers and cams.
CAUTION: DO NOT OVER-LUBRICATE, AND WIPE
OFF EXCESS OIL WITH A COTTON SWAB SOAKED
IN ALCOHOL. OTHERWISE, EXCESS LUBRICANT
MAY BE SCATTERED DURING OPERATION. AND
THE RUBBER COMPONENT PARTS WILL
DETERIORATE.
2. CLEANING TAPE HEADS AND OTHER
Wipe surface of tape heads, guide roller bearing, capstan
bushing and pinch wheel periodically with a soft cloth
soaked in alcohol or carbon-tet.
31