Akai XQB100-Y1066S - Connecting the Water Inlet Hoses

8
When the safety device works by abnormal swing of spin drum, machine works automatically to
stop Spin-Dry cycle and operates water supply valve to pour water into the Wash/Spin Tub and
then starts washing cycle for replacing washing clothes evenly.
After above operation has down twice, if safety device works again, machine will stop, and the
number window LED display abnormal code: and begin blinking on and off at the same time
and the electric buzzer sounds to indicate a problem.
• Open the Wash Lid and rearrange the clothes evenly around the Wash/Spin Tub.
• Close the Wash Lid and press the START/PAUSE button again.
f. Buzzing and rattling
Low
High
XQB100-Y1066S
Yes
No
Automatic
adjustment or
load.
Stop of Spin-Dry
Agitation of load (Rinsing
for 2 minutes).
Buzzing/rattling
during water
supply.
INSPECTION
Something in water valve.
Replace.
INSPECTION
Is high water
pressure (more
than 4kg/cm
2
)?
Faucet open too far
Adjust faucet
turning.
TROUBLE
INSPECTION
CAUSES
REMEDY
INSPECTION
Buzzing/rattling
during washing
or rinsing.
Does some noise
sound during
spin drying?
Belt is slipping.
Pulley is loose.
Some part touch motor
Adjust.
Tighten.
Repair or replace
Something underneath
pulsator.
Pulsator is rubbing.
Pulsator shaft is burnt.
Remove.
Adjust bearing ass
’
y.
Replace bearing ass
’
y.
Buzzing/rattling
during spin-dry.
Is sound in
low-pitched
monotone?
Bearings of bearing ass
’
y
is defective.
Replace.
Water supply