Akai XQB100-Y1066S - Getting Started: Installation; Unpacking; Installing the Bottom Cover; Levelling the Washer

7
e. Spin Drying
Yes
No
X
Operation of safety device
Spin drying cycle
does not work.
Does safety
device work?
Machine inclines.
Replace with level.
The V-belt is slipping.
The V-belt is snapped.
Small pulley mounting
screw is loosed.
Motor is disconnected or
burnt.
Capacitor is broken or
disconnected.
Bearing ass
’
y is defective.
Torque motor is defective.
Brake lever is defective.
Thermostat on motor is
opened.
Poor contact of 6-pin
connectors (blue &white).
Control circuit board is
defective.
Adjust the motor
position.
Replace.
Tighten up.
Replace.
Replace.
Replace.
Replace.
Repair or replace.
Repair or replace
after cooling down.
Repair or replace.
Replace.
Note:
1. The tub switch works 3 times
continuously or works 1 time in the
single program of spin-dry. The
number window LED display abnormal
code: and begin blinking on and
off at the same time and the electric
buzzer sounds to indicate a problem.
2. Do not disconnect the wire from the
capacitor, because this wire acts as
de-pressing noise from outside to the
micro-computer.
TROUBLE
INSPECTION
CAUSES
REMEDY
INSPECTION INSPECTION
Start of spin-drying.
Normal spin.
Safety device work.
Electric circuit
count operation of
safety device.
Electric circuit works to stop
spin when safety device
detects continuously three
times of abnormal swing of
spin drum.