Brake lining is worn out.
Brake lever ass
’
y is defective.
Foreign matter in drain
hose.
Pump lead wire is
disconnected.
Control circuit board is
defective.
No
No
d. Drain
Yes
No
XQB100-Y1066S
Note:
Break-work is
normal when spin
tub stops within 10
sec. under no-load.
Replace bearing ass
’
y.
Replace bearingl ass
’
y.
Water does not
drain out.
Repair or replace.
Replace.
Drain takes time
too long.
Drain hose ass
’
y is deformed.
Hose is connected in the
wrong way.
Hose is too long or position of
hose is too high.
Replace or replace.
Repair.
Repair.
.
Note: In draining, the water lever sensor can
not reset in 8minutes.
The number window LED display
abnormal code: and begin blinking
on and off at the same time and the
electric buzzer sounds to indicate a
problem.
Note: In draining, the water level sensor can
not reset in 8minutes.
The number window LED display
abnormal code: and begin blinking
on and off at the same time and the
electric buzzer sounds to indicate a
problem.
• If the Drain Hose is too long or high, water may overflow
during the rinsing cycle or make rinsing or draining impossible.
• The built-in pump is capable of discharging water to a maximum
height of 1.2 meters and minimum height of 0.8 meters.
• The pump makes a noise at the starting.
If you want to reduce the noise, please raise the opening end of
the Drain Hose above the floor 1 meter or more.
The pump makes an idling noise during washing.
This is normal.
Is the built-in pump
working normally？
To Next Page
Loading...
