Akai XQB100-Y1066S - Page 5

5
Does water stop
when the plug
is removed or
power switch is
OFF?
Bearing ass
’
y is defective.
Replace.
Motor wires are
dis-connected.
Capacitor wires are
dis-connected.
Capacitor is defective.
Motor coil shorten.
Brake lining on bearing
ass
’
y is worn out.
Brake lever ass
’
y is
defective.
Note: When removing the flow sheet, reinstate the filter in place correctly.
Yes
No
XQB100-Y1066S
c.Wash/Rinse
No
Yes
No
No
No
Yes
Yes
Water does not stop
Something in the air trap
hose or air leaks from a
part related water level
sensor system.
Water level sensor is
defective.
Control circuit board is
defective.
Something on the
diaphragm on the water
valve.
Diaphragm is deformed
Clean or replace.
Replace .
Replace.
Replace or
disassemble the
valve and clean
the diaphragm
Replace
Replace .
Replace
TROUBLE
INSPECTION
CAUSES
REMEDY
Washing cycle does
not start even if
water keeps the
selected water level.
Does the spin tub
rotated normally
when the
PROGRAM
button
is set to SPIN？
Bearing ass
’
y is defective.
Poor connect of 6-pin
connectors (blue & white)
Thermostat on motor is
opened.
Control circuit board is
defective.
Replace.
Replace.
Repair or replace
after cooling down.
Replace.
Does the pulsator
rotate by hand?
Replace or repair.
Replace or repair.
Replace.
Replace.
The spin tub rotates
together with the
pulsator during
washing or rinsing
cycle.
Is the torque
motor working
normally.
Replace bearing
ass
’
y.
Replace bearing assy.
Does brake-work
normally?
Does humming
noise come on
from motor？