SP2/SP4/SP8/SP8-X20 Manual
Updated until firmware 476 - 16 -
In this example we have selected the humidity sensor from the sensor menu on the left. The
sensors highlighted in green indicate that they are currently connected to the unit. In this case
you can see there is a temp and humidity sensor connected (dual sensor) and so they are
highlighted in green in the menu.
e) This window is used for configuring the sensors parameters. These parameters are explained
below :-
Description :- The name of the sensor. Use a meaningful name such as “humidity sensor
office1”
Go Online/Offline :- This takes the sensor on or offline without unplugging it from the unit
Critical high :- The %age humidity level at which it is critically high
To Next Page
Loading...
Need help?
General
