AKCP SP2+ User Manual

SP2+ Email Setup Manual
These parameters set the maximum number of times to send the email notification and the time interval
between each notification.
If you click on the Finish and Setup Notification button, this will launch the Link Notification Wizard
where you can use the new action for making a notification where you will link your connected sensors to
the email notifications.
Settings for office365
Important Note: Sending office365 email alerts are only supported on the SP+ F7 & H7 units running the
latest firmware on our website and are not supported on the older F4 type SP+ units.
First you need to ensure that the SMTP settings and the email action configuration are correct as follows
(our account is used as an example):

AKCP SP2+ Specifications

General

Brand	AKCP
Model	SP2+
Category	Measuring Instruments
Language	English