Notes:
1. Predrill a hole and insert the molly bolt into it. (For drill size,
please see the size reference table.)
2. Back the screw out about 1/4" and load the screw into the
setting tool.
3. Squeezing the handles to compress. When correctly inserted,
the screw can be removed from the anchor.
Check the video
on the YouTube
1.The piece that actually pulls the screw head is cut in a "V" shape,
so smaller screws work. It's just a little easier to lose your grip on
them if you're not careful.You have to be sure the shaft of the
screw is all the way down into the "V" and be sure the black
washer is added.
Use of Hollow Wall Anchor Tool
To Next Page
Loading...
