To minimize the risk of transmission of blood-borne pathogens, the cleaning and disinfection procedure
should be performed as recommended in the instructions below.
The meter should be cleaned and disinfected after use on each patient. This blood glucose
monitoring system may only be used for testing multiple patients when standard precautions and the
manufacturer’s disinfection procedures are followed.
Cleaning and Disinfection
The cleaning procedure is needed to clean dirt, blood and other bodily fluids off the exterior of the
meter before performing the disinfection procedure.
The disinfection procedure is needed to prevent transmission of blood-borne pathogens.
Clorox
®
Germicidal Wipes, with 0.55% sodium hypochlorite as the active ingredient, have been tested
and approved for cleaning and disinfecting the Assure
®
Prism multi blood glucose meter. This disinfectant
wipe has been shown to be safe for use with this meter. Please read the Clorox
®
Germicidal Wipes
instructions before using on your meter.
• Any disinfectant product with the EPA registration number of 67619-12 may be used on this device.
• A list of Environmental Protection Agency (EPA) registered disinfectants effective against HIV, Hepatitis B,
and C virus can be found at the following website:
http://www.epa.gov/oppad001/list_d_hepatitisbhiv.pdf
Go to www.arkrayusa.com/diabetes-management/disinfect for the most up-to-date information
on approved cleaning and disinfecting procedures and materials for ARKRAY blood glucose
meters. If you have any questions, please contact our Technical Customer Service department at
800.818.8877,
24 hours a day, 7 days a week, USA and Canada
.
Name Clorox
®
Germicidal Wipes
Manufacturer
Clorox Professional Products Company®
800.537.1415
www.cloroxprofessional.com
EPA Registration Number 67619-12
Active Ingredients 0.55% Sodium Hypochlorite
Cleaning and Disinfecting your Assure® Prism multi Blood Glucose Monitoring System
To Next Page
Need help?
General