Need help?Do you have a question about the Aksa DSE 6020 AMF and is the answer not in the manual?
General| Model | DSE 6020 AMF |
|---|---|
| Type | Control Panel |
| Frequency | 50/60 Hz |
| DC Supply | 8-35 VDC |
| Storage Temperature | -40 °C to +85 °C |
| Humidity | 95% non-condensing |
| Display | LCD |
| Output Voltage | 24 V DC |
| Alternator Input Frequency | 50/60 Hz |
| Magnetic Input Range | 0-400 V |
| Operating Temperature | -20 to +70 °C |
| Communication | RS232/RS485 |
Stops the generator, clears alarms, and can initiate remote start.
Allows manual control of generator functions, including starting and running off load.
Controls generator functions automatically, monitoring start requests and mains status.
Allows an on-load test of the generator by starting and running it.
Initiates the engine start sequence when in STOP/RESET or MANUAL mode.
Mode for automatic starting and stopping based on requests and mains status.
Allows manual start/stop and load switching.
Allows an on-load test of the generator.
Non-critical alarm conditions that alert the operator to undesirable conditions.
Shutdown due to missing engine CAN data link.
Shutdown alarm detected by the engine ECU.
To Next Page