Need help?Do you have a question about the AL-KO TSE 250 and is the answer not in the manual?
General| Brand | AL-KO |
|---|---|
| Model | TSE 250 |
| Category | Water Pump |
| Language | English |
Safety information regarding electrical connection, voltage, and cable requirements.
Details the intended applications for the submersible pump in home and garden settings.
Lists and identifies the components of the submersible pump as shown in Figure A.
Explains how the submersible pump works by sucking and pumping liquid.
Describes the thermal overload protection that switches the pump off and on.
Instructions on how to manually operate the float switch to drain residual liquid.
Guidance on adjusting the float switch cable to set pump start and stop levels.
Simple instruction on how to turn off the pump by unplugging it.
Steps for cleaning the pump after use, especially with chlorinated water.
Advice on how to store the pump to protect it from frost damage.
Troubleshooting steps when the motor fails to start or operate.
Diagnosing issues when the pump operates but does not discharge water.
Addressing problems with reduced or weak water output from the pump.
Steps to diagnose and fix issues when the pump's motor does not operate.
Resolving problems where the pump is on but not discharging any liquid.
Addressing performance issues of slow or weak water flow from the pump.
Diagram and reference numbers for components of TSE 250, TSE 350, and TSE 750 models.
Diagram and reference numbers for components of SPE 400 and SPE 700 models.
Diagram and reference numbers for components of the BVP 19000 model.
To Next Page
