EasyManua.ls Logo

AL-KO UP4 - Remote Control Error Diagnostics

AL-KO UP4
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
en
30 1659595_a
After approx. 6 minutes continuous pressing of a button:
After approx. 5 minutes, an acoustic signals sounds 5 times.
After approx. 6 minutes, this is repeated and the system switches to standby mode.
CAUTION!
Discharging of the battery!
After the automatic shut-off, the green control LED goes out, but the remote control stays in
standby mode with a low power consumption!
Turn off the main switch after use!
1. Turn off master switch (2G) and wait at least 1 second before turning on again to reactivate the
remote control.
Remote control error messages
The AL-KO "UP4" support system signals all error messages via the remote control with control LEDs
and/or an acoustic warning.
Control LED
Acoustic
signal
Meaning / Error message
2I (green)
OFF
OFF Remote control switched off and system not activated or
remote control in standby mode
2I (green)
steady light
OFF Remote control is ON and
system is ready for operation.
2I (green)
flashing constantly
OFF Remote control is ON, but there is no connection to the control unit.
Possible cause:
Remote control too far from control unit.
Main switch not turned on.
An interference signal interrupts the connection between remote
control and control unit.
As soon as the problem has been resolved and green control LED (2I)
has a steady light, the system is ready for operation again.
2L (blue)
2x flashing, pause
2x flashing, pause ...
Acoustic si-
gnal sounds
with the fla-
shing of the
control LED
Voltage of the caravan battery too low (< 10 V)
Charge the caravan battery!
2L (blue)
4x flashing, pause
4x flashing, pause ...
Acoustic si-
gnal sounds
with the fla-
shing of the
control LED
Voltage of the caravan battery too high (over-charged)
Discharge the caravan battery slightly be connecting consumers (e.g.
light or water pump)
2N (red)
6x flashing, pause
6x flashing, pause ...
Acoustic si-
gnal sounds
with the fla-
shing of the
control LED
The system’s overload protection has been activated.
Wait 60 seconds then try again.
1659595_a BA UP4 El_Caravanstütze ESS1 DIN A5 sw.pdf 30 08.11.2017 11:19:34

Table of Contents

Other manuals for AL-KO UP4