Read the following guidelines prior to installing the ALL200:
I. e ALL200 must be installed by a licensed, bonded and insured electrician.
II. e ALL200 must be installed level, in an accessible location and directly above the chandelier. If the
lift must be mounted directly above the xture and there is no access, provide an access panel or cut a hole
underneath the light lift and cover with a removable medallion.
III. For installation clarication, click the Youtube links or scan the QR codes located throughout the
Installation Instructions.
IV. oroughly read, understand and follow each step and safety warning in the ALL200 Installation
Instructions and orange safety precautions supplement.
V. During installation of the ALL200, take one step at a time and check o each step upon completion.
VI. e Troubleshooting Guide is located in the back of the Installation Instructions. Call Aladdin Light
Lift (877) 287-4601 if assistance is needed for installation and/or operation of the ALL200. Refer to the
Keyswitch Controller Guide or Smartlift Controller Guide for operation instructions.
VII. Ignoring any safety warnings and/or symbols not only voids the warranty, but may cause death,
personal injury and/or property damage.
VIII. e Warranty Agreement is located on the last page of Installation Instructions.
IX. Give all Aladdin paperwork to property owner and/or anyone that will be using ALL200.
ALL200 Parts Bag List
A. #10 x 1 ¼” Pan Phillips-Wood Screws (QTY 4)
B. 3/16” x 1” Fender Washers (QTY 4)
C. read Lock (QTY 1)
D. 3/32” Allen Wrench (QTY 1)
To Next Page
Loading...