Aladdin ALL200 User Manual

ALL200/ALL200-CM
INSTALLATION INSTRUCTIONS
Aladdin Light Lift, Inc. (256) 429-9700
61 Shields Road (877) 287-4601
Huntsville, AL 35811 www.aladdinlightlift.com
Patent #5105349
WARNING: Disconnect power source before servicing to avoid electrical shock
CAUTION: To Reduce the Risk of Electric Shock or Injury, Use Indoors Only.
Light and motor circuits are rated at AC 110V
Pour usage seulement dans un endroit
Avec acces au dessus du plafonds
Model Number: ALL200 (200lb. rated working load, 1/8” steel galvanized lay cable, 1.5amp, 50/60Hz)
__ MC Cable _(if checked)
Light lift is equipped with a 35’ cable unless checked below:
______65’
______90’
______120’
Light lift is equipped with a 1,650 watt (15 amps)
lighting capacity unless checked below:
______2200 watts (20 amps)
________________________ Electric Hoist
Manufacture Date © 2017 All Rights Reserved 91F5

Aladdin ALL200 Specifications

General

Brand	Aladdin
Model	ALL200
Category	Lifting Systems
Language	English

Summary

Installation Steps

Step 1: Determine Mounting Location

Guides on determining the mounting location, ensuring it's level and accessible directly above the chandelier.

Step 2: Electrical Box Preparation

Step 4: Attach Conduit Assembly

Step 5: Attach Second Conduit Connector

Step 6: Secure Temporary Weight

Step 7: Position and Adjust ALL200

Step 8: Adjust Ceiling Box Elevation

Step 9: Shim and Adjust for Plumb Cable

Step 10: Fasten ALL200 to Joists

Step 11: Wire Motor Switch

Details on wiring the motor switch with 110V wiring, keeping motor feed separate from light switch.

Step 12: Wire Light Switch

Guides on wiring the light switch with 110V wiring, keeping light neutral separate and noting dimmer compatibility.

Step 13: Prepare Winch Drum

Step 17: Test Motor and Shut-Off

Guides on testing the motor and automatic shut-off system by running the unit to the CEILING POSITION.

Step 18: Position for Chandelier

Step 19: Unscrew Weight

Step 20: Attach Chandelier to Coupler

Guides on threading the chandelier's screw collar loop or stem to the 1/4 IPS fixture coupler.

Step 21: Attach Chandelier Canopy

Step 22: Adjust Chandelier Chain

Step 23: Adjust Canopy and Conduit

Instructions for adjusting the canopy and telescopic conduit assembly so contact plates meet before canopy touches ceiling.

Step 25: Run Chandelier Wires

Step 26: Wire Chandelier Connections

Details on wiring chandelier hot, neutral, and ground wires to the bottom contact plate wires.

Step 27: Tighten Fixture Coupler Set Screws

Step 28: Apply Liquid Thread Lock

Step 29: Replace Canopy and Ring

Step 30: Confirm Cable Plumbness

Step 31: Operate to Ceiling Position

Guides on operating the ALL200 to the CEILING POSITION, testing lights, and contacting support if needed.

Troubleshooting Guide

ALL200 Does Not Operate

Provides diagnostic steps for when the ALL200 unit fails to operate, including checking switches, fuses, and wiring.

Chandelier Will Not Light

Offers troubleshooting steps for when the chandelier fails to illuminate, including checking contact plate paint and fuses.

Improper Shut Off at Ceiling Position

Advises to discontinue use and contact Aladdin Light Lift immediately if the unit does not shut off properly.