LED color Status Description
AP Mode
To enter AP mode, push the WPS
button and release when flashing
white (about six seconds). To add
the camera to the user's router and
account using AP mode, see AP
mode.
Factory reset
LED color Status Description
Factory reset
Caution: This restores factory-
default settings to the camera.
If already installed, the camera may
need to be removed from the
Alarm.com account and re-added
after a factory reset. To perform a
factory reset, push the WPS button
and release when flashing Green
and Red (about 15 seconds).
Troubleshooting
• If issues occur when connecting the camera to the account, power cycle the camera. Unplug the power jack from
the camera for about one minute, and then plug it back in to restore power.
• If issues persist, reset the camera to factory defaults by using the WPS button located on the back of the camera.
Press and hold the WPS button for about 15 seconds until the LED is flashing green and red, then release the
button. The camera reboots with factory defaults. If the camera was previously installed to an Alarm.com account, it
needs to be deleted before it can be installed again.
For further troubleshooting, contact Alarm.com CORE technical support.
Questions?
For general information about video set up and frequently asked questions, see Video - General.
https://answers.alarm.com/Installation_and_Troubleshooting/Video_Devices/Indoor_Fixed_w%2F%2FIR_ADC-V522IR/Indoor_Fixed_w%2F%2FIR_(ADC-V522IR)_-_Installation_Guide
Updated: Fri, 21 Sep 2018 18:29:15 GMT
4
To Previous Page
Loading...