3
❶
❺
❷
❸
❹
❻
In the box
• V523 camera
• Mounting plate
• Power supply
• User guide
• Wall anchors & screws (x2)
Overview
V523
topside
V523
underside
❶ LED indicator
❷ Mounting plate
❸ Reset button
❹ MAC address + QR code
❺ SD card door
❻ Base plate
2 3
Installation
Connect the camera to the Wi-Fi network
AP mode
To ensure sufficient Wi-Fi signal, complete these steps with the
camera near its final location but prior to mounting.
1. Connect the camera’s AC power adapter and plug it into a
non-switched outlet.
2. The camera’s LED will begin to flash white. If the LED is not
white after two minutes, hold down the Reset button
and
release when the LED begins to flash white (about 6 seconds).
3. On an Internet enabled device, connect to the wireless network
“ADC-V523 (XX:XX:XX)” where XX:XX:XX is the last six
characters of the ADC-V523’s MAC address, which is located on
the bottom of the camera or on the packaging.
4. On the same device, open a web browser and enter “http://
v523install” in the URL field. Follow the on-screen instructions to
add the ADC-V523 to the Wi-Fi network. The LED will be solid
green when the connection is complete.
5. Add the device to the account by either selecting the account in
MobileTech or by using a web browser and entering the following
URL: www.alarm.com/addcamera (you will need the customer’s
user name and password if using the Customer Website).
6. Select the camera from the video device list or type in its MAC
address to begin adding the camera. The camera’s MAC address
is located on the bottom of the camera or on the packaging.
7. Follow the on-screen instructions to finish adding the camera.
You may configure camera settings from the Customer Website.
You can now power down the camera and install it in its final
location using the included hardware.
Connect the camera to the Wi-Fi network
WPS mode
To ensure sufficient Wi-Fi signal, complete these steps with the
camera near its final location but prior to mounting.
1. Connect the camera’s AC power adapter and plug it into a
non-switched outlet.
2. Hold down the Reset button
on the bottom of the
camera and release when the LED begins to flash blue
(about 3 seconds).
3. Activate the WPS mode on the router. The camera will begin to
connect to the wireless network. The LED will be solid green
when the connection is complete.
continued
To Next Page
Loading...
Need help?
General
