Alarm Controls Corporation TS-2T User Manual

RED
LED
REAR VIEW OF PLATE
NEGATIVE ( BLACK ) LEAD
POSITIVE ( RED ) LEAD
ALARM CONTROLS CORPORATION
19 BRANDYWINE DRIVE P.O. BOX 280
DEER PARK, NY 11729
PH: 1 800 645-5538 1 631 586-4220 FAX ; 1 631 586-6500
WWW.ALARMCONTROLS.COM EMAIL: INFO@ALARMCONTROLS.COM
MOUNT WALLPLATE IN A
VERTICAL POSITION
MODELS TS-2T, TS-3T, TS-4T & TS-5T
SHOULD BE MOUNTED IN A 2.5 INCH
DEEP ELECTRICAL BOX
TIME ADJUSTMENT
MAXIMUM TIME TURN POT
TOWARD PLATE
MINIMUM TIME TURN POT
AWAY FROM PLATE
TIME RANGE: 2 TO 45
SECONDS
TIMER INPUT VOLTAGE
12 TO 24 VOLTS AC OR DC
NON-POLARIZED
CURRENT DRAW: 60 MA.
MAXIMUM
GRAY LEADS
INTERNAL LED
LED ( BLACK ) NEGATIVE LEAD
LED ( BROWN ) POSITIVE LEAD
TIMED OUTPUT CONTACTS
RATED 2 A, @ 35 VDC
VIOLET LEAD N/O CONTACT
GREEN LEAD COM CONTACT
BLUE LEAD N/C CONTACT
NOTE: TIMER WILL ACTIVATE WHEN PUSH TO EXIT SWITCH IS DEPRESSED.
SUBSEQUENT DEPRESSIONS OF THE SWITCH WILL RE-START THE TIMER.
LED CURRENT DRAW
4 MA. @ 12 VDC
15 MA. @ 24 VDC
LED OPERATES ON 12/24 VDC
GRAY
BLACK
VIOLET
GREEN
BLUE
BLACK
BROWN
RED
GRAY
RED LED 12/24 VOLTS DC
RED LED ONLY ON TS-3T, TS-5T
LED CURRENT RATING
9 MA. @ 12 VDC, 19 MA. @ 24 VDC
DOC. D-007 REV. B
4/09
INSTALLATION INSTRUCTIONS
MODELS TS-2T, TS-3T, TS-4T, TS-5T
U.L. FILE SA32686

Alarm Controls Corporation TS-2T Specifications

General

Brand	Alarm Controls Corporation
Model	TS-2T
Category	IP Access Controllers
Language	English

Summary

Rear View Plate Details

Component Identification and Wiring

Identifies LEDs, input voltage, output contacts, and their associated wiring colors on the rear of the plate.

Time Adjustment Procedure

Explains how to set the timer duration using the turn pot by adjusting it towards or away from the plate.

Mounting Guidelines

Specifies vertical mounting for the wallplate and the requirement for a 2.5-inch deep electrical box.

Operational Behavior Note

Clarifies timer activation logic via the push-to-exit switch and its behavior on subsequent presses.

Typical Wiring Diagrams

Magnetic Lock Wiring Diagram

Illustrates wiring for a magnetic lock using the TS-2T model with a power supply and push-to-exit button.

Electric Strike Wiring Diagram

Shows wiring for an electric door strike (fail-secure mode) using the TS-2T model and a push-to-exit button.