1 | P a g e
TILE FAN INSTRUCTION MANUAL
READ AND SAVE THESE INSTRUCTIONS
Suspended Ceilings-Grid Mount Only!
Patent Pending
CAUTION!
All electrical connections must be in accordance with the local codes, ordinances, and the National electrical Code. If you are unfamiliar with methods of
electrical wiring, secure the services of a qualified electrician.
1. Be sure electricity is turned off at the main fuse box or circuit breaker panel before wiring.
2. Be cautious! Read all instructions and safety information before installing your new Tile Fan.
WARNING! TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT USE THIS FAN WITH ANY SOLID-STATE SPEED CONTROL
DEVICE.
WARNING! TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR INJURY TO PERSONS, OBSERVE THE FOLLOWING;
a) Use this unit only in the manner intended by the manufacturer. If you have questions contact manufacturer.
b) Before servicing or cleaning unit, switch power off at service panel and lock the service disconnecting means to prevent power from being
switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a prominent warning device, such as a tag
to the service panel.
NOTE: The important safeguards and instructions appearing in this manual are not meant to cover all possible conditions and situations that may occur.
It must be understood that common sense, caution and care are factors which cannot be built into this product. These factors must be supplied by the
person(s) installing, caring for and operating the unit.
WARNING!
1. Installation and wiring should be done by the dealer or authorized person (the installation construction must be done in
Accordance to the wiring regulations of the country.
2. Never alter the product or its specifications.
3. Do not install the fan on the wall or floor.
4. Operate the Product at the rated voltage and frequency for the country indicated on the name plate.
5. This fan must be grounded.
6. Install this product over 2.5m above the ground.
7. Install this product on the ceiling placing the suction opening downward and install it horizontally.
8. Disconnect power source before working on unit.
9. Do not turn on the fan when inflammable gas leaks are present.
10. Do not install and operate in places with high temperature.
11. Do not install and operate in places with oil fumes.
12. This product is not provided with flexible cord and plug or with other means for disconnection with the supply when connecting or changing
cable; it must be replaced by qualified persons in order to avoid a hazard. Please use 227 IEC S3 (RVV) or wire which thickness of tube is
1mm or above. Please use appropriate cable of three wicks, with cross
section of 3x1.5mm² or above.
13. Do not install this product exposed to water such as a shower.
14. To avoid electric shock or fire, do not remove the PCB cover.
15. This appliance is not intented for use by persons (including children) with reduced physical sensory or mental capabilities, or lack of
experience and knowledge, unless they are given proper supervision or instructions concerning use of appliance by a person responsible for
their safety. Children should be supervised to ensure that they do not play with the appliance during maintenance.
16. Not for use in kitchens.
17. This product is not intended for connection to rigid metal conduit.
AVERTISSEMENT !
POUR REDUIRE LE RISQUE D'INCENDIE, DE CHOC ÉLECTRIQUE OU BLESSURES, OBSERVER SUIVANT:
1. Utilisez l'appareil uniquement selon les instructions du fabricant. Si vous avez des questions, contactez le fabricant à l'adresse ou le numéro
de téléphone, il listé dans la garantie.
2. Avant de réparer ou de nettoyer, coupez le courant au panneau de service et verrouiller service de déconnexion signifie pour éviter une mise
en marche accidentelle. Lorsqu'ils ne sont pas possible de verrouiller le dispositif de sectionnement, fixer solidement un signe d'avertissement
(Comme une étiquette) dans un endroit visible sur le panneau de service.
3. Un ou plusieurs personnes qualifiées doivent effectuer des travaux d'installation et le câblage électrique, selon toute codes et normes, y
compris les codes et les normes de protection spécifiques d'incendie du bâtiment.
4. Lorsque vous coupez ou percez un mur ou un plafond, veillez à ne pas endommager le câblage électrique et les autres services publics
cachés.
5. Installez cet appareil uniquement sur un plafond plat.
6. Pour une utilisation uniquement dans des installations sans résistance au feu.
7. Ne pas utiliser des espaces pour traiter l'air ambiant.
8. Cet appareil doit être mis à la terre.
To Next Page
Need help?
General