SPECIFICATIONS
2PF290082080002
2019/01 V0
FCC
Federal Communications Commission Statement
This device complies with FCC Rules Part 15. Operation is subject to the following
two conditions:
• This device may not cause harmful interference.
• This device must accept any interference received, including interference that
may cause undesired operation.
This equipment has been tested and found to comply with the limits for a class B
digital device, pursuant to Part 15 of the Federal Communications Commission
(FCC) rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment causes harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by doing one or more
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Caution
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user‘s authority to operate the equipment.
Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. End users must follow the specific operating instructions for
satisfying RF exposure compliance. The antenna(s) used for this transmitter must not
be co-located or operating in conjunction with any other antenna or transmitter.
•To ensure accurate readings, clean the sensor lens with a soft and dry cloth.
•It is recommended to wash the armband with warm water (under 40°C). DO
NOT use the brightener, soap or softener. DO NOT soak, iron, dry clean, bleach
and twist.
HOW TO CLEAN
The sensor only comes with one button; the operation of different uses is
described as follows:
BLUETOOTH AND LED INDICATORS
Heart Rate Zone*
Z1
Warm Up
Increase speed and lactate threshold;
Only suitable for short-distance pace,
cannot maintain for a long time
Z2
Z3
Z4
Z5
Easy
Aerobic
Threshold
Maximum
Training intensity
% (%MHR)
~60%
75%~
60-75%
LED Flash
frequency
Low speed
Intermediate
speed
High speed
Training functions
Facilitate warm-up and energy
recovery
Improve metabolism
Enhance aerobic fitness
Notes
When the sensor is recording or connecting to Bluetooth, low battery light will not be ON.
The user can upload the recorded data to Ala Connect through Bluetooth communication.
When LED is constant ON, the sensor will turn off automatically if there is no operation or
connection over 3 minutes.
Blue /Red LED flash frequency varies according to user’s heartbeat in the heart rate zone at
that time:
* The sensor will define your heart rate zone according to the age and maximum heart rate
(%MHR) input in Ala Connect
Charge
Charging
Fully charged
Activate
Power on
Standby
Low battery
Note 1
When used as an independent training device
Start recording
Stop recording
Bluetooth connection
Pairing
Synchronizing data
Note 2
When used as an accessory for heart rate monitor and paired with compatible devices
Heart rate detected
Heart rate not detected
Green
Flash
Constant ON
Note 3
Flash
Blue
Constant ON
Note 3
Flash
Constant ON
Note 3
Flash
Note 4
Red
light up
Constant ON
Note 3
Blinking
Note 4
Constant ON
Note 3
Button
operation
Long press
Short press
Short press
!
1
2
3
4
• Model: OB001
• Dimension: L 48×W 31.5×D 12.5mm
• Armband: L 380×W 25mm
• Weight: 13g (armband excluded)
• Memory capacity: Up to 30 hours training
• Operating temperature: -10~60°C (-14~140°F)
• Charge temperature: 10~45°C (50~113°F)
• Wireless transmission interface: Bluetooth 4.0/ANT+
• Wireless transmission frequency: 2.402~2.480 GHz
• Battery: rechargeable lithium battery
• Input voltage: 5V
• Run time: 40 consecutive hours (max.)
To Previous Page
Loading...
Need help?
General
