Loading Software onto the Switch Managing System Files
page 1-26 OmniSwitch AOS Release 6 Switch Management Guide September 2009
1 Connect your terminal emulation device containing the Zmodem protocol to the switch’s console port.
2 Start the Zmodem process on your switch by executing the rz command.
-> rz
A screen similar to the following will appear.
Upload directory: /flash
rz ready to receive file, please start upload (or send 5 CTRL-X’s to abort).
**B000000023be50
3 Transfer the files by using your terminal emulation software. The following will be displayed.
ZMODEM file transfer successful,
Hit <RETURN> to exit...
When the transfer is complete, you can use the ls command to verify that the new files were loaded
successfully. To abort a Zmodem session enter Ctrl-X five times in succession.
Note. Files transferred via Zmodem are loaded into the flash directory. Before the new files can be used by
the switch, you must transfer them to the switch’s /flash/working directory and reboot the switch.
To Next Page
Loading...
