OmniTouch 4135 IP
Installation Guide
ENGLISH
110131-61-001 Rev 2a
This installation guide explains how to install the OmniTouch 4135 IP and make the basic
settings. For further instructions, please visit www.alcatel-lucent.com where you’ll nd a user
guide with full details of all the features as well as the “Installation and Administration of
OmniTouch 4135 IP” manual with a detailed description of all connection options and settings.
Connecting
Connect the OmniTouch 4135 IP
to the network with the provided
cable as illustrated below.
The OmniTouch 4135 IP is ope rated
directly from the network (Power over
Ethernet). If the network does not
supports this, a power adapter may be
purchased as accessory.
Place the conference phone in the middle
of the table.
The conference phone can be registered in a company SIP switch or PBX or with a public IP
telephony service provider. You can store settings for two accounts in the OmniTouch 4135 IP.
To register your phone, you must have access to the account information and all the settings that
the SIP switch or service provider requires.
Select Settings > SIP.
Enter the account information you have received.
Account name: Here you choose the name or phone number you want to appear in the
phone’s display.
Leave the default values if you have no other information.
Select a method of NAT traversal if this is required.
Save the settings by clicking the Save button.
The OmniTouch 4135 IP responds by showing REGISTERING. If the registration is successful, your selected
account name appears at the bottom of the display with a shaded square in front of it.
In some cases, it may also be necessary for you to make security settings on the Media tab.
See “Installation and Administration of OmniTouch 4135 IP”.
REGISTER AN ACCOUNT
SD memory card port
Expansion
microphone
port
Power supply
Security lock port
AUX port
Network cable port
Expansion microphone port
To Next Page
