Alcatel-Lucent Stellar AP1251 - Ap1251

Stellar AP | Deployment & Configuration & Troubleshooting Guide 37 |
P a g e
All rights
reserved. Passing on and copying of this document, use and
communication of its contents not permitted without written authorization from HAN-Networks.
# tftpboot 0x42000000 OAW-AP1230-UBOOT_FIRMWARE_3.0.x.x.bin
# nand erase 0x0 0x10000000 && nand write 0x42000000 0x0 $filesize &&
nand read 0x42000000 0x3000000 $filesize
# nand read 0x43000000 0x0 $filesize && md5sum 0x43000000 $filesize
# nand read 0x44000000 0x3000000 $filesize && md5sum 0x44000000
$filesize
# reset
✓ After AP reboot, entering below commands to make dual system working.
# fm_switch
# reboot
4.4.5 AP1251
Procedure of the upgrading AP1250 Series through bootloader:
✓ To setup a TFTP server on a PC, and put the images on the TFTP server path:
 OAW-AP1250-UBOOT_FIRMWARE_3.0.x.x.bin
✓ To enter the bootloader during AP initialization, which is described in 4.4.1.
✓ Network configuration (IP Address, TFTP Server Address…)
Example: IP address= 172.16.18.11 ; TFTP Server Address= 172.16.18.129
# set ipaddr 172.16.18.11
# set serverip 172.16.18.129
# save