What to do if Alcove NPVWM Vacuum Cleaner suction becomes weak?
If the suction of your Alcove Vacuum Cleaner becomes weak, you should: * Empty the dust collector. * Clean the filter. * Check whether the Recharging Base is plugged into the outlet. * Remove objects within 1 m to the right and left side and within 2m to the front.
What to do if my Alcove NPVWM Vacuum Cleaner robot suddenly stops?
If your Alcove Vacuum Cleaner robot suddenly stops, you should: * Check whether the power level is too low. * Check whether the robot is stuck or trapped by an obstacle. * Check whether any debris blocks the suction inlet.
Why Alcove NPVWM robot cannot be activated?
If your Alcove Vacuum Cleaner robot cannot be activated: * Check whether the power switch is turned on. * Check whether the battery has been charged. * Replace the batteries in the remote control (2 type AAA batteries). * Make sure the remote control is within range (less than 3m).
What to do if Alcove NPVWM robot cannot find its way home?
If your Alcove Vacuum Cleaner robot cannot find its way home, you can: * Dust off the recharging contact pins with a dry cloth. * Ensure the Sonic Wall is not installed too close to the Recharging Base.
What to do if Alcove Vacuum Cleaner robot's movements are abnormal?
If the Alcove Vacuum Cleaner robot's movements or cleaning path are abnormal, you should: * Clean the sensors carefully with a dry cloth. * Restart the robot.
How to fix Alcove NPVWM roller brush that does not rotate?
If the roller brush of your Alcove Vacuum Cleaner does not rotate, you should: * Clean the roller brush. * Check whether the roller brush has been installed properly.
What to do if Alcove NPVWM robot gets stuck (E1 error)?
If your Alcove Vacuum Cleaner robot gets stuck or trapped while cleaning (E1 error), turn off the robot and restart it in a new location.
What to do if Alcove NPVWM robot's bumper is stuck (E3 error)?
If the bumper of your Alcove Vacuum Cleaner robot is stuck (E3 error), tap the robot bumper several times to dislodge any debris that may be trapped underneath.
What to do if Alcove NPVWM Vacuum Cleaner robot's cliff sensors are dirty?
If the cliff sensors of your Alcove Vacuum Cleaner robot are dirty, clean the cliff sensors with a dry cloth.
General| Brand | Alcove |
|---|---|
| Model | NPVWM |
| Category | Vacuum Cleaner |
| Language | English |
To Next Page