First use
10
− Never attempt to clean the light by immersing it in water and
do not use a steam cleaner to clean it. Otherwise, you may
damage the light.
− Never place the light in a dishwasher as this will destroy it.
− Stop using the light if its plastic parts or the light itself show
cracks or breaks or are deformed. Replace damaged parts only
with compatible original spare parts.
− The use of accessories and parts not expressly recommended
by the manufacturer may cause injury or damage and will void
the warranty.
First use
Checking the light and package contents
NOTICE!
Risk of damage!
If you are not cautious when opening the packaging with a sharp
knife or other pointed objects, you may easily damage the light.
− Open the packaging with great care.
1. Take the light out of the packaging.
2. Check to make sure that all contents have been delivered (see Fig.A).
3. Check whether the light or its components show signs of damage. If this is the
case, do not use the light. Contact the manufacturer at the service address
specified on the warranty card.
Inserting or changing batteries
1. Open the 4 battery compartment covers
5
on the rear of the light and remove
any old batteries first (see Fig. B).
2. Insert one 1.5 V AA/LR6 battery in each compartment. Make sure the polarity
(+/–) is correct. The battery’s negative pole must be pushing on the respective
spring contact.
3. Put the battery compartment covers back on.
To Next Page
Loading...
Need help?
General
