Mounting
11
Mounting
The light can be mounted in two ways:
• Installed on a vertical pole, for example, of a parasol
• Suspended using the hanging loops
Installation on a pole
1. Release the locking mechanism
4
by folding it upwards (see Fig.C).
2. Unfold the light and place the two halves around the pole. The light is compatible
with pole diameters of 25 to 45 mm.
3. Push the two halves together and secure them in place using the locking
mechanism. The spring clamp
6
will hold the light securely on the pole (see Fig. D).
The light can be installed in either directions, with the LEDs facing upwards (indirect
lighting) or downwards (direct lighting).
Suspending the light
− To mount the light this way, fold up the two hanging loops
7
and hang the light
on a hook or by a string (see Fig. E).
Use
Switching the light on and off
1. Press the On/Off switch
3
once to switch the light on. The bulbs in light ring 1
(4 LEDs)
1
will light up.
2. Press the On/Off switch again. The bulbs in light ring 2 (24 LEDs)
2
will light up.
3. Press the On/Off switch for a third time. All LEDs will light up.
4. Press the On/Off switch for a fourth time. This will turn off the light.
Cleaning
NOTICE!
Risk of short circuit!
Water or other liquids that have penetrated the housing may cause
a short circuit.
− Never immerse the light in water or other liquids.
− Make sure that no water or any other liquids enter the casing.
To Next Page
Loading...
Need help?
General
