Cleaning and care
17
2. Connect the charger to a properly installed socket only.
The status indicator
4
on the charger shows the current
status of the battery and charger (see chapter “Status
indicators on the charger”).
3. Unplug the charger from the mains socket once the battery
has been fully charged.
4. Slide the battery towards the mains cord
2
to remove it
from the charger.
If a problem occurs during the charging process, disconnect
the charger from the mains supply.
Status indicators on the charger
• LED lights up green: Operating voltage reached/
charging process completed
• LED flashes green: Battery is charging
• LED flashes red: Error while charging
• LED lights up red: Temperature warning
Cleaning and care
WARNING!
Risk of burns!
The charger will heat up during use.
− Always let the charger cool off
completely before you clean it.
To Next Page
Loading...