EasyManua.ls Logo

ALDI autoXS - Product Safety and Usage; Safety Information; Battery Replacement Instructions; Included Components

ALDI autoXS
4 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Instructions
Please read these instructions thoroughly before using,
then store in a safe place for future reference.
SAFETY INFORMATION
This is not a toy. Keep it out of reach from small children.
Do not use spotlight when it is charging.
Never look directly into the spot light when illuminated.
Electrical requirements for the adaptor: 100-240 V, 50/60 Hz
BATTERY REPLACEMENT INSTRUCTIONS
When replacing the battery, be sure to:
• Unscrew the front cover of the light and disconnect the wire plug from
the heat dissipation. (see Figure A & B)
• Unscrew the rear cover and take out the battery housing by removing 2
screws behind the rear cover. (see Figure A & C)
• Use rechargeable battery only. Battery specication is Li-ion 3.7 V
2200 mAh, 1 pc is needed.
• Observe the correct polarity (+ and -) when installing the replacement
battery.
• IMPORTANT: Dispose of the Lithium ion battery in accordance with local,
state and federal regulations.
THE CONTENT INCLUDED:
Hand strap X 1
Adaptor (1000 mA) X 1
Car adaptor (1000 mA) X 1
Whistle X 1
Warranty Card X 1
Instruction Manual X 1
SPECIFICATIONS:
LED type: COB
Two brightness levels: 100% (approx. 300 Lumen) and 50% (approx. 150
Lumen)
• Working time with 100% brightness levels mode 90 min.
• Working time with 50% brightness levels mode 210 min
Battery type: Li-ion, 18650, 3.7 V 2200 mAh
Colour temperature: 5000-6500 K
Beam distance: 300 m
Dimensions (L x W x H): 14.61 x 15.49 x 7.75 cm
IP44 rated weatherproof
AC charging time: 1.5 - 4 hrs
DC charging time: 1.5 - 4 hrs
!
!

Related product manuals