Models: AEC 20-4.0Ia / AEC 20-4.0Ic / AEC 20-4.0Na
XYZ563
Please note the technical specifications for the battery and the charger.
Warning: The stated vibration emission value was measured using a standardised
test procedure.
The actual vibration emission value can differ from the stated value, depending on
the kind of use. This can significantly increase the vibration load throughout
operation.
The actual vibration emission value can differ from the stated value, depending on
the kind of use.
The vibration level can be used for comparisons with other power tools.
It is also suited for a preliminary estimation of the vibration load.
For an exact estimation of the vibration load, you should also take into account the
time during which the device is switched off, or is running but not actually being
used. This can significantly decrease the vibration load throughout operation.
Establish additional safety measures to protect the operator from the impact of
vibrations, for example: servicing power tools and insertion tools, keeping hands
warm, carrying out work steps in an organised sequence.
Please observe the following: according to the German Machine Noise
Protection Regulation from September 2002, this device may not be
operated on Sundays and Bank holidays or working days from 8pm to
7am. Furthermore, it is forbidden to operate the machine at the
following times of day: from 7 a.m. to 9 a.m., from 1 p.m. to 3 p.m. and
from 5 p.m. to 8 p.m. Please do also consider any local regulations
concerning noise protection!
Keep noise emissions and vibrations to a minimum!
- Only use perfectly functioning devices.
- Clean and service the device regularly.
- Adapt your way of working to the device.
- Do not overload the device.
- Have the device checked, if necessary.
- Switch the device off when it is not in use.
- Wear protective gloves.
Technical data
19
To Next Page
Loading...
