ALDI FERREX XG-KF2000 - Normal procedure for Stopping the Engine; Overload procedure for restarting and resetting the engine

24
Digital Inverter Generator with Pure Sine Wave
AFTER SALES SUPPORT
e-mail: info.aldi@positecgroup.com
1300 889 028
MODEL: №. XG-KF2000 • 03/2020 • 700069
(toll free)
AFTER SALES SUPPORT
(toll free)
e-mail: info.aldi@positecgroup.com1300 889 028
Digital Inverter Generator with Pure Sine Wave
MODEL: №. XG-KF2000 • 03/2020 • 700069
red load status indicator (5) LED will illuminate. The generator will continue to
supply 240Va.c output for a very short time, but if the load is not reduced, the
240V supply will be automatically shut down. To reduce load rstly you can
stop using one appliance and turn it o , see if that recties the problem. If not
refer to page 15 on loading’s and how they work. If this does NOT solve your
problem, or you do not reduce load fast enough, the output of the generator
will be automatically shut down, and the petrol motor will continue to run.
You will now need to reset the overload condition by shutting down the petrol
motor (Fig P), and thus restart the engine after the load being applied to the
generator has been reduced. Refer to the Overload procedure for re-starting
and re-setting the engine. Always connect the largest appliance you want to
run rst allowing it time to draw current to start . After 20-30 seconds connect
the second appliance.
Normal procedure for Stopping the Engine
(Full shut down and Store)
1. Turn “OFF” the 240Va.c Outlet Power On/O switch (1) by pushing the
switch to the right hand side to the "O" position. (Fig R).
2. Remove any appliances connected to either of the 2 outlets (Fig H).
3. Allow the engine to slow down and idle for approx 15-30 seconds.
4. Press the engine On/O switch (2) to the “OFF” position as indicated by an
“O” (Fig. S). The unit will stop running.
5. Turn the fuel lever / tap (23) clockwise to the “OFF” position (Fig. T).
NOTE: Turn o the fuel safety switch (34) if the engine still runs after operating
the above procedures (Fig. J1).
Overload procedure for restarting and resetting the engine
1. Turn “OFF” the 240Va.c Outlet Power On/O switch (1) by pushing the
switch to the right hand side. (Fig R).
R.
S.
T.