,A.Pleasereadthefollowinginformationthoroughlyand
/1<l\
keep
this booklet
so
that
you
can
refer
to it in future.
\I/
;i'"'":'j,#,15:'.'#:,?:?lJ$
;1,';,','rHone
er se'
Startup and lnstallation
1
.
Remove
the battery compartment
cover
from
the device.
2. lnsert the batteries into
the battery compartment
(6).Pay
attention
to
the correct
polarity.
Positive
(+)
terminal must
correspond with
positive
(+)
marking.
3. Re-attach the battery
compartment cover.
Basic
Functions
Ca libration
Follow
below steps to check if
the device
is
calibrated correctly.
.
Press
the ON/SET
button
(3)
to turn the device
on.
.
Remove
the
protective
cap
(9)
from
the
device and
identify
the
markings
"8"
and
"T"
on
it.
-
Hold the measuring
tips
(1)against
the test contacts
(8)
marked
with
"B".
The scales
on the display should blink.
.
Hold
the
measuring
tips
(1)against
the test contacts marked with
"T".
The left
scale should
display a
value
of 19o/o
(+/-
1o/o).
.
lf
you
can
confirm the above the
device
is ready for
use.
.
Re-attach the
protective
cap
(9)
.
B
El
support@eurocentra.com.au
M0DEL: E(-MMT-0'l
PR0DUCT(0DE:48817 06i2018
AFTER SATES
SUPPORT
a@
Toll free
To Next Page
Loading...
Need help?
General