EasyManua.ls Logo

ALDI Workzone Titanium+ 62007 - Troubleshooting; No electrical output; Repeated overload; Generator overheating

ALDI Workzone Titanium+ 62007
21 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Digital Inverter Generator with Pure Sine Wave
AFTER SALES SUPPORT
e-mail: help@powertoolsupport.com
1800 909 909
MODEL: №. EP2800i • 09/2018 • 62007
(toll free)
AFTER SALES SUPPORT
(toll free)
Digital Inverter Generator with Pure Sine Wave
e-mail: help@powertoolsupport.com1800 909 909
MODEL: №. EP2800i • 09/2018 • 62007
36 37
AC output: 240Vac ~ 50Hz
Rated power: 2000W +/- 5%
Peak power: 2200W +/- 5%
Phase: Single
Displacement: 135cc
Motor: 4 stroke
No load speed: 3500 RPM +/- 10%
Fuel tank capacity: 7L
Fuel type: Unleaded
Oil tank capacity: 550ml +/- 10%
Oil type: 4 Stroke (SAE 10W-30)
Net weight: 19kg
Product Dimensions: 44.5cm x 36.5cm x 37cm (L x W x H) +/- 10%
This product complies with: Safety:
AS/NZS 3010: 2017
AS/NZS 3100: 2017
For other issues not covered in this chart, please call Customer Service on 1800 909 909.
Troubleshooting Specications
Trouble Possible cause Suggested remedy
No electrical output
1. Faulty receptacle 1. Have service centre replace receptacle
2. Overload has been triggered
(red Overload light on).
2. Remove all appliances. Stop the
generator, and restart. Reconnect
appliances but with reduced load.
3. Faulty power cord 3. Have an electrician replace cord.
4. 240Va.c Outlet Power On/Off switch (1)
turned off.
4. Check the 240Va.c Outlet Power On/
Off switch (1) is “ON”.
Repeated overload
1. Overload 1. Reduce load
2. Faulty cords or equipment 2. Check for damaged, bare, or frayed
wires on equipment. Replace.
Generator overheating
1. Generator overloaded 1. Reduce load
2. Insufficient ventilation 2. Move to adequate supply of fresh air
3. Octane rating of fuel too high 3. Drain fuel and use 91 octane rated
unleaded fuel
Generator keeps stopping,
or is operating rough
1. Check oil level 1. Add oil so oil is at the correct level.
Refer page 21-22 of this manual.
2. Generator not sitting on flat
and level surface
2. Move generator to a level and
flat surface
3. Motor needs to be cleaned of carbon 3. Remove, check and clean spark
arrestor if needed.
Remove, clean or replace spark plug (20)
Specifications
Accessories and After Sales
Should you nd any of the following accessories are worn or past their user
life, replacements can be purchased at https://help.tools/
1. Air Filter (62007-AF) 2. Recoil Starter (62007-RS)
Consistent with our product development program, improvements may have been made
which render the contents of the products packaging or user instructions slightly dierent to
the product shown.

Related product manuals