-106-
Network:
Network settings: To set the network settings of the NVR. Make sure that the router
to which the NVR is connected is set to DHCP.
NIC: Network Interface Card (only 1 interface card present)
IP: IP address for the network (advice: obtain the IP address by checking “Via
DHCP”).
Subnet mask: Enter the subnet mask (not functional when using DHCP).
Default gateway: Enter the default gateway (not functional when using DHCP).
DNS server address1: Optionally, enter the DNS server address.
DNS server address2: Optionally, enter the DNS server address.
MAC address: MAC address of the NVR.
Default route: Select NIC1
Device port: Port 5050 is selected by default. This may be changed into any
desired port number.
HTTP port: Default internet port 80.
RTMP port: Port for using RTMP (Real Time Messaging Protocol), especial-
ly for streaming connections.
Enable RTSP: A check-mark means RTSP (Real Time Streaming Protocol) is
activated. Additionally, several RTSP settings are available.
NTP settings: A setting for synchronizing the built-in clock with a NTP (Network
Time Protocol) server.
Management platform: Access authorization to the NVR.
To Next Page
Loading...
