What to do if my Aleratec 1:11 HDD Copy Cruiser IDE/SATA Disc Duplicator LCD display is not working?
If the LCD display of your Aleratec Disc Duplicator is not working, first check that the power cable is properly connected. Also, ensure that the ON/OFF switch is turned on.
What to do if my Aleratec 1:11 HDD Copy Cruiser IDE/SATA shows error messages?
If your Aleratec Disc Duplicator is displaying error messages, power the unit off. Wait about ten seconds, and then reapply power to restart the system.
General| Type | Disc Duplicator |
|---|---|
| Target Drives | 11 |
| Supported Interfaces | IDE, SATA |
| Host Interface | USB 2.0 |
| Maximum Data Transfer Rate | 480 Mbps |
| Operation | Standalone |
| Model | Aleratec 1:11 HDD Copy Cruiser IDE/SATA |
| Supported Drive Types | HDD |
| Power Supply | 100-240V AC, 50/60Hz |
| LED Indicators | Power, Error |
| Copy Modes | 1:11 |
To Next Page
