Alert-it P137 User Manual

UQ1043 Quick Start P137 Pager.ppp Page 1of 3 v8.1 26/04/2017
Shows battery
status
Name of alarm
will flash up
when safety
signal received.
Bars on right
show strength
of signal
Indicates there is
an alarm system
in the area, not
paired to this
pager. This may
be OK or an error
so check with the
supervisor
(Charger can
be left
permanently
connected or
it can boost
charge from
empty in 8
hours)
Press menu for 3 seconds to turn on. (If no
response, then charge battery for at least 5
minutes)
Enter MENU (see overleaf)
Scroll right to Turn Off & then Select (up arrow)
Do not remove batteries as this can damage the connec-
tions.
Radio contact with
an alarm fitted with
“Safelink” security
has been lost. This
MUST be corrected
immediately i.e.
Epilepsy Alarms
Typical alarm
indication. with
four levels:
Urgent, Help,
Assist, Fault
Quick Start Guide to using the P137 Advanced Pager
Try walking towards the user’s room. If the alarm cancels
then there is a problem with the building or distance
required. Contact Alert-It who can offer a signal booster
or if RF Fail does not cancel then:
1. Look for signs of damage and the status of
LED’s/Display on clients equipment.
2. Check the user equipment is turned on.
3. Contact Alert-It for further advice
1. Attend the user,
2. Reset the alarm on the user’s equipment and
the pager will return to normal operation
automatically
(Increased tone indicates more alarms are active.
See over for snooze and view.)

Alert-it P137 Specifications

General

Brand	Alert-it
Model	P137
Category	Pager
Language	English

Summary

Turning on the pager

Turning Off the Pager

Instructions for powering down the device safely without removing batteries.

Typical screens in normal operation

Understanding Operational Indicators

Explains battery status, area alarms, and signal strength indicators on the screen.

Troubleshooting RF Fail

Steps to take if the RF Fail alarm does not cancel, checking client equipment and contacting support.

Alarm active

Alarm Indication Details

Describes typical alarm displays like "Urgent", "Help", "Assist", "Fault" and how to reset.

Setting up

Entering Setup Mode

Guide to entering the setup menu by pressing and holding the menu button.

Silencing Alarms

How to silence alarms temporarily or view active alarms.

Sound and Vibrations

Configuring Sound Options

Details on adjusting settings like light, vibrate, tunes, key beep, and RF tune.

Safety Information

General Safety Precautions

Essential safety guidelines for power, cleaning, placement, and accessory use.

Support and Compliance

Technical Support Contact

Information on how to contact Alert-It for technical assistance and support email.

System Compliance

Details on the system's compliance with medical device directives and radio standards.