Alert-it Plesio Pager User Manual

V2.1 UQ1399A P168A Quickstart for standard systems.doc Page 3 of 8
The Alert-iT Plesio Pager can be used to provide a monitoring system for
domestic, and similar environments where it can replace the more complex
professional P137 and P138 pagers.
Turning on the Plesio Pager
Please note: While the pager is shipped with some charge in the batteries, it
is recommended that the pager is charged before use. (See overleaf).
To turn the Pager on, press and hold the ON/OFF button for 3 seconds. The
pager will beep and all three LEDs will flash. The green Pager LED will blip
every 8 seconds to show that the pager is awake and listening for alarm
signals.
 If the Pager is turned on and paired with a Safelink Monitor, the red
“Monitor” LED on the pager will blip every 8 seconds.
Turning off the Pager
To turn the pager off, press and hold the ON/OFF button for 3 seconds. The
pager will bleep and all three LEDs will flash 3 times.
Figure 2.
Pair / Mute
Monitor LED
Alarm LED
Pager LED
On / Off

Alert-it Plesio Pager Specifications

General

Brand	Alert-it
Model	Plesio Pager
Category	Monitor
Language	English