Alert-it Pulse Companion - User Manual

How to turn on the armband
To turn on the armband press and hold the power button
for 5seconds.
Adjust the sensor strap and fit where appropriate.
Instructions for use
Thank you for purchasing the
Pulse Companion
Using the Pulse Companion
How to turn on the pager
Turn on the pager by pressing and holding the menu
button for 3seconds a pip noise will sound.
Pulse 00 should appear on the screen every 8 seconds
after start up.
How to turn on the Pulse Companion
To turn on the Pulse Companion, press and hold
•
•
•
button for 3seconds.
The Pulse Companion will automatically pair to the
armband supplied with this equipment.
The LED will flash green rapidly when connecting.
The LED on the Pulse Companion will now flash green
every 4 seconds, you are now in monitoring conditions.
Press and hold
for 5 seconds
Press and hold
•
•
•
button for
3seconds
Status lights
Adjust strap for
optimal fit and
performance
Green LED will flash
to confirm connection
Press and hold until
screen turns on
“Battery“ or “charging“
will appear in normal
mode.
“Pulse 00” will
appear onscreen

Summary

Pulse Companion Setup and Operation

Armband Power On Instructions

Learn to turn on the armband by holding the power button for 5 seconds and adjusting the strap.

Pulse Companion Activation Guide

Activate the Pulse Companion by pressing its button, noting automatic pairing and LED confirmation.

Pager Power On Procedure

Switch on the pager by holding the menu button; observe screen and audio cues for startup.

Pulse Companion Disconnection and Standby

Armband Power Off Guide

Steps to turn off the armband by pressing and holding its power button for 5 seconds.

System Standby Mode Activation

Place the Pulse Companion and pager into standby mode by holding the designated button.

Alert-it Pulse Companion Specifications

General

Brand	Alert-it
Model	Pulse Companion
Category	Personal Care Products
Language	English