. .
31
PROGRAMMING
Exit: Turn Ignition to ON position, or leave it for 15 seconds.3 long
chirps and 3 parking light flashes will confirm programming exit.
SAFE START (Child safety mode)
Factory defaults setting to press the
button twice to start the vehicle.
Programming this feature to eliminate an accidental remote start, when kids
enter this transmitter, it requires: The user press the transmitters
and
buttons at the same time to start the vehicle.
START FEATURE # 2 PRORAMMING:
1. Turn the Ignition switch ON and OFF 3 times and leave it in the
OFF position.
2. Press the valet/program switch 10 times and then hold it in on the
10
th
press until five chirps followed by 1 long chirp is heard, release
the valet/program switch. You are now in the START FEATURE #
2 PROGRAMMING MODE.
3. Press and release the transmitter button that corresponds to the feature
you desire to program.
START FEATURE CHART #2
One Chirp with
Press One LED Pulse
Transmitter Factory Default Two Chirps with
Three Chirps with
Four Chirps with
Button Setting Two LED Pulses
Three LED Pulses
Four LED Pulses
1 Exit the programming mode. (3 long chirps and 3 parking light flashes
will confirm programming exit.)
2
+ Engine Checking Engine Checking Engine Checking Engine Checking
Voltage TACH / RPM Negative Oil Positive Oil
Learning Mode Sensor Sensor
3
Start Timer: 0.8-second (2 chirps), 1.0-second (3 chirps) 1.2-second
0.6-second (4 chirps), 1.4-second (5 chirps), 1.6-second (6 chirps),
1.8-second (7 chirps), 2.0-second (8 chirps), 3.0-
second (9 chirps), 4.0-second (10 chirps.
4
Low check level Hi check level
5
-
Start or stop the system for TESTING AND ADJUSTMENT
6
+
3 Hour Time 2 Hour Time
Start Start
To Next Page
Loading...