What to do if sound is distorted on Alesis AI-3 Media Converter?
If the sound from your Alesis Media Converter is distorted and the red “Clip” LEDs are lit, it probably means the input level is too high. Try turning down the input source.
How to fix hum or noise from Alesis AI-3 Media Converter output?
If you are getting hum or noise from the output of your Alesis Media Converter, it may be due to a ground loop. Try plugging the unit into another power jack or using different audio cables.
What to do if no signal going to the ADAT output on Alesis AI-3?
If there's no signal going to the ADAT output on your Alesis Media Converter, the “Optical Source” switch might be in the wrong position. Check the setting of the “Optical Source” switch on the front panel.
Why Alesis Media Converter has low signal level?
If you are experiencing a low signal level with your Alesis Media Converter, it could be because the “Operating Level” switch is in the wrong position. Check the setting of the “Operating Level” switch on the front panel.
How to resolve low signal level on Alesis Media Converter?
If you are experiencing a low signal level with your Alesis Media Converter, it might be due to mixing balanced and unbalanced cables. Choose balanced or unbalanced cables throughout your studio.
How to fix Alesis AI-3 Media Converter display when it does not light?
If the display of your Alesis Media Converter does not light up when you power it on, it might be because there is no power. Check that the power cable is plugged in properly.
Guide on how to effectively read and use the manual for optimal understanding of the AI-3.
Explains the meaning of safety symbols used in the product literature to alert users to hazards.
Lists essential precautions for safe operation, handling, and installation of the AI-3.
Details the process of unpacking the AI-3, checking contents, and retaining packaging for potential returns.
Describes the eight analog inputs and outputs, their function, and signal levels for the AI-3.
Determines the signal source for the ADAT Optical Digital output (Analog In or Optical In).
Controls the analog input/output signal levels, settable to -10dBV or +4dBu.
Shows signal level into the AI-3; SIGNAL LED (-20 dBfs), CLIP LED (-2 dBfs).
Turns the unit on; crucial for overall operation and advice validity.
Explains the critical concept of digital clocking in studios and AI-3's interaction with master/slave sources.
Provides a table to help identify and resolve common operational problems with the AI-3.
Covers cleaning procedures and emphasizes that all servicing must be performed by qualified personnel.
Outlines the process for getting the AI-3 repaired, including contact information and warranty considerations.
General| Brand | Alesis |
|---|---|
| Model | AI-3 |
| Category | Media Converter |
| Language | English |
To Next Page
