Alfa Network AIP-W525H V2

To Next Page

Presentd by

www.PcXpert.org

AIP-W525H_V2 Wifi Repeater, also called Wifi Extender setup

Before you start, read this entire document.

Configuration Alfa AIP-W525H in "Repeater" mode

This setup allows you to connect the AIP-W525H on an existing router, the connection

between the two Routers is wireless. In "Repeater" mode, DHCP is disabled, the main

router assigns all IP addresses to connected devices. All computers connected to both

routers can communicate with each other. The Repeater can use the same or can have

its own wifi name [SSID]. In "Repeater" mode the AIP-W525H can be placed anywhere,

as long as it can reach the wireless Network you want connect to.

Important:

Before you configure your AIP-W525H, you must know the wireless network name

[SSID] and password (security key) of your existing router.

1. Simplified setup: connect the AIP-W525H to a Power source, connect a network

cable to your computer and the other end to one of the routers LAN ports.

Main Page

Need help?

Do you have a question about the Alfa Network AIP-W525H V2 and is the answer not in the manual?

Summary

Introduction and Preparation

Repeater Mode Configuration

Configures the AIP-W525H in "Repeater" mode for wireless connection to an existing router.

Simplified Setup Procedure

Connect the AIP-W525H to power, then connect a network cable from the device to your computer.

Accessing and Initializing the Device

Opening the Web Interface

Access the device's configuration by typing its IP address (192.168.2.1) into a web browser.

Understanding Operation Modes

Describes various modes like Router, AP, Wireless ISP, Repeater, and Client for the device.

Core Repeater Setup

Setting Operation Mode to Repeater

Navigate to Operation Mode, select 'Repeater', and apply changes to reboot the router.

Configuring Basic Repeater Settings

Set the SSID, channel width, and enable Universal Repeater Mode in Basic Settings.

Establishing Wireless Connectivity

Performing a Wireless Site Survey

Access Site Survey to scan for available wireless networks and locate the main router's SSID.

Connecting to the Main Router

Select the main router's SSID from the survey results and click 'Connect'.

Finalizing the Connection

Confirm successful connection and click 'Reboot Now' to apply all changes.

Advanced Configuration Options

Modifying the Repeaters LAN IP Address

Optionally change the Repeater's LAN IP address for easier access, noting the main router's address.

Setting a Custom Repeater SSID

Set a unique SSID for the repeater to distinguish it from the main router's network.

Security and Finalization

Implementing Password Protection

Configure wireless security using WPA2 and a Pre-Shared Key for secure network access.

Wireless Security Setup Interface

Access the Wireless Security Setup page to configure encryption, authentication, and pre-shared key.