Need help?Do you have a question about the ALFA TERM 20 and is the answer not in the manual?
General| Power | 20 kW |
|---|---|
| Heating Area | Up to 200 m² |
| Thermostat | Yes |
| Overheat Protection | Yes |
| Frequency | 50 Hz |
Details three safety measures: regulator, thermal valve, and safety valve for safe operation.
Specifies placement options and required distances from flammable materials for safe installation.
Discusses flue draft requirements and recommended pipe sizes for optimal performance.
Covers flue pipe connections, sealing, and insulation requirements for proper function.
Lists required components like thermal valve, pressure regulator, and filters for safe operation.
Details the optimal placement for the thermal fuse probe for effective operation.
Explains the installation and setting of the slope pressure regulator for system pressure.
Details the necessity and placement of water filters for boiler intake and outlet.
Specifies the mandatory installation of a safety valve and its pressure rating.
Explains the function of the built-in thermometer and manometer for monitoring system status.
Provides advice on system sealing, pressure testing, and draining before commissioning.
Recommends the size and placement of the expansion vessel for system stability.
Details how to fill and vent the heating system for open and closed setups.
Guides on how to start the fire and adjust regulators for initial operation.
Explains how to move the grate between lower and upper positions for different uses.
Describes how the thermostat adjusts air intake based on water temperature.
Recommends grate position for efficient cooking, baking, and frying.
Lists approved heating materials and their thermal power ratings.
Outlines daily ash removal and monthly cleaning procedures for the stove.
Addresses issues like slow pressure decrease and low/high system pressure.
Covers problems like cold radiators or uneven heating along the length.
Diagnoses issues with the circulation pump not switching on or making noise.
Addresses problems where gauges do not show correct temperature or pressure.
Covers issues like weak flue draft, leaky seals, or incorrect heating material.
Addresses stove overheating, smoke release, and grate sticking during cleaning.
To Next Page