What causes noise inside the alfaplam Alfa Term 35 pump?
Noise inside the pump of your alfaplam Other could be due to pressure being too low at the suction part of the pump. Increase system pressure or check the expansion vessel.
What to do if my alfaplam Alfa Term 35 Other is smoking during regular use?
If your alfaplam boiler-cooker is smoking during regular use, several factors could be the cause. First, the chimney, flue pipes, and cooker might need cleaning, so clean the inside of these components. Second, the fuel might be wet or generate a lot of smoke; in this case, change the fuel to dry or smokeless fuel. Also, the firebox might be overloaded; load it slowly and gradually in several steps. Finally, the chimney might be of poor quality; consider repairing or rebuilding it.
What causes a sudden water pressure rise in alfaplam Other?
A sudden water pressure rise in your alfaplam Other system, caused by a water temperature increase, can occur if the expansion vessel pressure is reduced or the vessel is completely empty. To address this, remove the cover or vessel valve cap and release some air through the valve. If water leaks out, the membrane is damaged. If only air comes out, the vessel was half empty. Another possible cause is air in the installations, so release air from the system.
Why is alfaplam Alfa Term 35 circulation pump not working?
If the circulation pump in your alfaplam Other does not activate or trips the switch, it could be due to several reasons. First, there might be no power at the electrical connection or loose connectors. Check and tighten all screws at the connection points. If necessary, replace the switches or fix any motor or installation connection problems. Another cause could be a faulty capacitor, which would need replacement. A blocked rotor could also be the problem; check whether the rotor turns easily each time you start heating, and turn the motor axis left and right using a screw gun until it moves freely. Lastly, the pump could be blocked due to deposits; in this case, dismantle and clean the pump.
How to fix noise coming from alfaplam Alfa Term 35 Other heating system?
If you are experiencing noise coming from your alfaplam Other heating system, several factors could be the cause. The pump might be malfunctioning, with a large clearance between the rotor axis and nut; in this case, reduce the pump speed and consider replacing the pump nuts or the entire pump. Alternatively, the pump speed might be too high, so lower the speed. Air in the installations can also cause noise; bleed the air from the heating system. Lastly, loose knobs or screws on the cooker can vibrate; tighten them.
What to do if my alfaplam Alfa Term 35 has outlet water temperature not right (too low)?
If the outlet water temperature of your alfaplam Other is too low, it could be due to several reasons. The fuel might have a low calorific value; in this case, change the fuel. The heating system might be too large, with too many radiators; turn off some radiators. Also, not enough fuel might have been loaded in the firebox; increase the quantity of fuel.
Why is water pressure in alfaplam Alfa Term 35 Other dropping slowly?
If the water pressure in your alfaplam Other system is dropping slowly, it could be that the installation is not sealed properly. Check whether all welded connections, threaded connections, unions, etc., are sealed.
What to do if alfaplam Alfa Term 35 Other thermometer or pressure gauge is not working?
If the thermometer or pressure gauge on your alfaplam Other is not displaying the system temperature or water pressure, the thermometer or pressure gauge is likely faulty and needs replacement.
What to do if alfaplam Alfa Term 35 has too much heat during baking, cooking?
If you're experiencing too much heat during baking or cooking with your alfaplam Other, the thermostat might be set to a high temperature. Reduce the water temperature using the thermostat or burn a smaller fire.
Why is there water condensation in my alfaplam Alfa Term 35 boiler?
If you notice water condensation in the boiler of your alfaplam Other, it could be due to wet fuel; replace the fuel. Alternatively, the return water temperature might be too low; install a mixer valve or turn a radiator off.
To Next Page
General