29
WIN 7/WIN 8
zadig-2.5.exe
No installation required
To install the driver, make sure the machine is powered
on and connected to the computer via USB.
The installation process can only be carried out when
the machine is in the powered-on state and connected
to the computer.
No installation required
WIN 10/WIN 11
Mac
To check the driver installation, follow these steps:
① Find the Device Manager on your computer.
② Navigate to the Ports section.
③ Disconnect the USB cable from the computer.
④ Observe that the new serial port disappears from the Ports section.
⑤ Reconnect the USB cable.
⑥ Verify that a new serial port appears, indicating successful driver installation.
Connecting the machine
① Launch the LaserGRBL / LightBurn software.
② Select the COM port that corresponds to the one identified in step two of the
installation process.
③ Click on the “Connect” button.
④ If a welcome message appears in the command box,
it indicates a successful connection.
Operating
System
Operation
Phenomenon
To Next Page
Loading...