ALIBI ALI-NS1014VR - Login to the Camera; Access Camera via Web Browser; Install WebComponents Plugin

3
www.observint.com
© 2015 Observint Technologies. All rights reserved.
6. Close the Alibi Tools Utility by clicking the Close icon ( T ) in the upper-right corner of the screen.
Step 4. Login to the camera
To access the camera from a computer on the LAN:
1. Open your Microsoft Internet Explorer (IE) browser on your computer and enter the IP address of the
camera in the URL eld. In the example below, the IP address of the camera is 192.168.75.76.
2. In the login window, enter your User Name and Password in the appropriate elds, then click
Login. The default User Name and Password for Alibi cameras is admin and 1111.
3. If the password you enter for your camera is a weak password, the following pop-up window will
appear. Follow the instructions to create a “strong” admin password.
NOTE
Observint recommends using strong passwords in all of your surveillance devices. Strong passwords
have a minimum of 8 characters with upper case and lower letters, numbers and special characters.
And we recommend you reset your password regularly, especially in high security systems. Resetting
the password monthly or weekly will better protect your security system from hackers and criminals.
4. If this is the rst time you are logging into a camera and are you are using Internet Explorer 10 or
newer, a message may appear at the bottom of the window to use ActiveX Controls. Click Allow.
5. If this login is the rst login to an Alibi camera from your computer and browser, continue with the
following sub-steps to install WebComponents:
a. After a successful login to the camera, a message will appear in the middle of the Live View
window requiring you to load a plug-in. Click on the message to continue, then click Run in
the pop-up block at the bottom of the screen.
NOTE
Some computer security software may attempt to block you from running WebComponents.exe. If
necessary, open the Internet Explorer downloads list, right click on the WebComponents.exe le name,
then click Run Anyway.
b. In the Setup - WebComponents window opens, click Next to continue.